Technical specification
| Model | LP-F4020-10kW |
|---|---|
| Laser power | 10 kW |
| Cutting area | 4000×2000 mm |
| Max. sheet thickness | 20 mm carbon steel / 16 mm stainless steel / 12 mm aluminium |
| Repeat positioning accuracy | ±0.02 mm |
| Max. positioning speed | 150 m/min |
Applicable materials
- Carbon Steel1–20 mm plate, roughly 9 m/min on 6 mm mild steel
- Stainless Steel 304 / 3160.5–16 mm with nitrogen assist for a bright, oxide-free edge
- Aluminium 5052 / 60611–12 mm with clean cut faces and minimal dross
- Galvanized SheetUp to 6 mm with low coating damage at the cut edge
Key capabilities
Full-width panels fit without splitting, eliminating weld seams and the associated distortion, inspection and finishing costs in structural fabrication.
A welded steel base with a composite bed holds positional stability over long cycles, keeping accuracy at ±0.02 mm on heavy plate.
Cutting parameters are validated for high-strength and wear-resistant steels up to 16 mm, supporting the thicker sections used in chassis and structural work.
Pallet lengths and support rollers can be specified so one machine serves both 3000 mm coil and 4000 mm sheet production without changeover delay.
Machine video
Get machine recommendation and pricing
Send the model with your inquiry — our engineers reply with cutting parameters, cycle time and delivery.
相关案例
A 6 kW workhorse in a 3000×1500 mm bed, cutting 3 mm cold-rolled steel at about 30 m/min and mild steel up to 16 mm. This is the volume-production choice for automotive brackets and agricultural panels where a single shift must clear several tonnes of sheet.
The 40 kW flagship with an 8000×2500 mm bed, cutting 30 mm carbon steel in one pass and handling the largest structural blanks in the LaserPeak range. It targets shipbuilding, defence platforms and heavy equipment where very thick plate is cut as single pieces.
The 20 kW LP-F6025 cuts 20 mm carbon steel and works across a 6000×2500 mm bed for heavy structural plate. Built for shipbuilding, defence and large machinery, it replaces oxy-fuel lines with a cleaner, faster and far more precise process.
The 4 kW LP-F4020 brings a 4000×2000 mm bed to shops that cut mostly thin and medium sheet. It cuts 3 mm carbon steel at about 15 m/min and 6 mm at roughly 7 m/min, with lower operating cost and simpler maintenance than higher-power installations.
The 12 kW LP-F3015 is built for heavy-gauge throughput: roughly 8 m/min on 6 mm carbon steel and 5 m/min on 10 mm, with 20 mm capacity at full power. It serves structural, agricultural and defence fabricators who cut thick plate without oxy-fuel consumables.