Technical specification
| Model | LP-F1503-1.5kW |
|---|---|
| Laser power | 1.5 kW |
| Cutting area | 3000×1500 mm |
| Max. sheet thickness | 6 mm carbon steel / 4 mm stainless steel / 5 mm aluminium |
| Repeat positioning accuracy | ±0.02 mm |
| Max. positioning speed | 100 m/min |
Applicable materials
- Stainless Steel 304 / 3160.3–4 mm thin gauge parts with a narrow heat-affected zone
- Carbon SteelUp to 6 mm, around 5 m/min on 3 mm mild steel
- Aluminium 5052 / 60610.5–5 mm for brackets, covers and enclosure panels
- Galvanized SheetUp to 3 mm with minimal zinc burn-back on the cut edge
Key capabilities
The 1.5 kW resonator consumes a fraction of the power of a comparable CO2 source while running continuously in multi-shift job shops, cutting thin sheet without thermal distortion.
Short pierce times and low spatter keep small blank geometry accurate, helping operators hold ±0.02 mm repeatability on complex outlines and tab-and-slot features.
A half-length table suits small-batch nesting and gives shops a compact footprint while retaining the full-height frame for 3000 mm material.
Job data, cut time and material utilisation are logged from the control panel, giving production managers a running cost per part on every job.
Machine video
Get machine recommendation and pricing
Send the model with your inquiry — our engineers reply with cutting parameters, cycle time and delivery.
相关案例
A 10 kW laser on the 4000×2000 mm bed for large-format panels in one piece. It cuts 6 mm carbon steel at about 9 m/min and handles 20 mm plate, giving structural, vehicle-body and enclosure manufacturers a single machine for full-width blanks with no part splitting.
The 4 kW LP-F4020 brings a 4000×2000 mm bed to shops that cut mostly thin and medium sheet. It cuts 3 mm carbon steel at about 15 m/min and 6 mm at roughly 7 m/min, with lower operating cost and simpler maintenance than higher-power installations.
The 40 kW flagship with an 8000×2500 mm bed, cutting 30 mm carbon steel in one pass and handling the largest structural blanks in the LaserPeak range. It targets shipbuilding, defence platforms and heavy equipment where very thick plate is cut as single pieces.
A 6 kW workhorse in a 3000×1500 mm bed, cutting 3 mm cold-rolled steel at about 30 m/min and mild steel up to 16 mm. This is the volume-production choice for automotive brackets and agricultural panels where a single shift must clear several tonnes of sheet.
The 12 kW LP-F3015 is built for heavy-gauge throughput: roughly 8 m/min on 6 mm carbon steel and 5 m/min on 10 mm, with 20 mm capacity at full power. It serves structural, agricultural and defence fabricators who cut thick plate without oxy-fuel consumables.