Technical specification
| Model | LP-F6025-30kW |
|---|---|
| Laser power | 30 kW |
| Cutting area | 6000×2500 mm |
| Max. sheet thickness | 30 mm carbon steel / 25 mm stainless steel / 20 mm aluminium |
| Repeat positioning accuracy | ±0.02 mm |
| Max. positioning speed | 110 m/min |
Applicable materials
- Carbon Steel3–30 mm, roughly 2.5 m/min on 25 mm plate and 1.5 m/min on 30 mm
- Stainless Steel 304 / 3160.5–25 mm with nitrogen assist for a bright, dross-free edge
- Aluminium 5052 / 60611–20 mm with stable cutting on heavy sections
- Galvanized SteelUp to 12 mm with low coating burn-back and a narrow kerf
Key capabilities
The 30 kW resonator cuts 25 mm carbon steel at about 2.5 m/min and 30 mm at roughly 1.5 m/min, compressing heavy-plate job times substantially.
Ships, defence vehicles and large machinery frames are cut from one plate rather than fabricated from welded sections, cutting labour and distortion.
The bed and gantry are sized for 30 kW thermal load and heavy plate mass, holding positional accuracy and cutting stability over long production days.
No oxygen, propane or abrasive is consumed on heavy plate, and cut-edge quality removes a large share of grinding and weld preparation.
Machine video
Get machine recommendation and pricing
Send the model with your inquiry — our engineers reply with cutting parameters, cycle time and delivery.
相关案例
The 40 kW flagship with an 8000×2500 mm bed, cutting 30 mm carbon steel in one pass and handling the largest structural blanks in the LaserPeak range. It targets shipbuilding, defence platforms and heavy equipment where very thick plate is cut as single pieces.
The 12 kW LP-F3015 is built for heavy-gauge throughput: roughly 8 m/min on 6 mm carbon steel and 5 m/min on 10 mm, with 20 mm capacity at full power. It serves structural, agricultural and defence fabricators who cut thick plate without oxy-fuel consumables.
The 20 kW LP-F6025 cuts 20 mm carbon steel and works across a 6000×2500 mm bed for heavy structural plate. Built for shipbuilding, defence and large machinery, it replaces oxy-fuel lines with a cleaner, faster and far more precise process.
A 10 kW laser on the 4000×2000 mm bed for large-format panels in one piece. It cuts 6 mm carbon steel at about 9 m/min and handles 20 mm plate, giving structural, vehicle-body and enclosure manufacturers a single machine for full-width blanks with no part splitting.
The 4 kW LP-F4020 brings a 4000×2000 mm bed to shops that cut mostly thin and medium sheet. It cuts 3 mm carbon steel at about 15 m/min and 6 mm at roughly 7 m/min, with lower operating cost and simpler maintenance than higher-power installations.